Plumbing pumps
Plumbing Pump Repair and Installation
Gravity moves most water in a building. Pumps handle the rest: groundwater under the basement, waste from below-grade bathrooms, and hot water that needs to circulate.

01Sump & ejector pumps
Different pumps solve different problems, and they are not interchangeable. A sump pump removes groundwater that collects under and around a foundation. A sewage ejector pump lifts wastewater from a basement bathroom or laundry up to a sewer line that sits higher. A grinder pump chops solids before pumping waste through a small pressure line. A recirculation pump keeps hot water moving so it reaches the tap faster.
What they share is that failure is usually sudden and messy. A float switch sticks, a check valve fails, a motor burns out, or the power goes out during a storm. Most failures can be traced to one component, and many are preventable with a basic check.
We repair, replace and install plumbing pumps for homes and commercial properties, with 24/7 emergency service when a pump stops during heavy rain or a basement starts backing up.
02When to call
Signs it's time
- 01Water in a basement or crawl space that has a sump pit
- 02A pump that runs constantly, cycles on and off rapidly, or never runs
- 03Sewage odor or slow drains in a basement bathroom
- 04An alarm sounding on a sump or ejector basin
- 05Humming without pumping, or loud grinding and rattling
- 06Long waits for hot water at distant fixtures
03How we handle it
- 1
Identify the pump and the job it does
We confirm what kind of pump it is, where it discharges, and what is feeding it before diagnosing.
- 2
Test the controls
Float switches, alarms and power supply are checked first, because they are the most common failure points.
- 3
Check the discharge side
We inspect the check valve and discharge line for backflow, clogs or freezing outdoors.
- 4
Repair or replace
We repair the failed part or replace the pump with one sized for the basin and the lift height, then test a full cycle.
04What's included
The scope, in plain terms
- Sump pump repair and replacement
- Battery and water-powered sump backup systems
- Sewage ejector pump repair and installation
- Grinder pump repair and installation
- Hot water recirculation pumps and lines
- Float switch, check valve and alarm service
- Discharge line repair and rerouting
Specific plumbing pumps services
05Questions
What people ask about plumbing pumps
What is the difference between a sump pump and a sewage ejector pump?
A sump pump handles groundwater, which is relatively clean. A sewage ejector handles wastewater from toilets, sinks and showers, so it is built to pass solids and sits in a sealed, vented basin. They should never be swapped for each other.
Why does my pump run constantly?
Common causes are a stuck float, a failed check valve letting water fall back into the pit, an undersized pump, or a very high water table during wet weather. Diagnosing which one decides the fix.
Do you handle pump emergencies after hours?
Yes. A failed sump or ejector pump is a common after-hours call, and we offer 24/7 emergency service.
Plumbing Pumps in these towns
- Bloomfield
- Boonton
- Caldwell
- Cedar Grove
- Clifton
- Fairfield
- Franklin Lakes
- Hackensack
- Lincoln Park
- Little Falls
- Livingston
- Madison
- Midland Park
- Montclair
- Montville
- Morristown
- Mountain Lakes
- North Caldwell & West Caldwell
- Nutley
- Oakland
- Paramus
- Parsippany
- Pequannock
- Pompton Plains
- Ridgewood
- South Orange
- Totowa
- Wayne
- West Orange
- Wyckoff
Request service
Tell us what's going on.
We'll get back to you to set a time. Anything urgent, call instead: (973) 513-7751.
